DIMLUX - EXPERT SERIES 1000W NANOTUBE DE EL UHF + BULB BLV HORTURION 1000W DE EL 2.2 PLUS
The Dimlux Expert Series 1000W NANOTUBE DE EL UFH is undoubtedly one of the most effective lighting systems on the market today, producing higher yields and better quality output than is possible...
Recalculation in progress … Luminaires with NANOTUBE are equipped with 2 bushings with a diameter of 50mm that can be used to dissipate the heat produced by the reflector and significantly reduce the ambient temperature. (up to 200m²/h of fresh air per luminaire) By using NanoTube the air can be drawn in parallel so that the room temperature decreases. The lamps will always maintain the ideal temperature and thus efficiency and lifespan will become even higher.
Key features Dimlux Expert Series 1000W NANOTUBE DE EL DHF:
- Combined lamp, ballast and reflector
- Offers 10% higher efficiency than standard HPS lights
- Very high frequency operation of the ballast (140Khz) increases light output from the bulb in the active photosynthetic spectrum
- Operates from a standard 230 volt domestic power supply
- Extremely high PAR levels (usable plant light)
- Very low operating temperatures
- Highly efficient with extremely low heat output
- Alpha Optics 98 reflector for wonderfully uniform light diffusion
- Supplied with BVL Horturion 1000W / 400V DE EL UHF 2.2 Plus PPF lamp at 1200W - 2470 mmol
- Suitable for illuminating an area between 1.65 and 4sqm depending on the power and needs of the variety being grown.
1 x power cable 4.0m
Technical specifications Dimlux Expert Series 1000W NANOTUBE DE EL DHF:
- Dimmable to 7 different wattages:
Soft Off
600 Watt
700 Watt
800 Watt
900 Watt
1000 W
1100 W
1200 Watt
- Soft-Start technology when used without Maxi Controller
- Zero-Start technology when used with Maxi Controller
- Dimmable according to environmental conditions when used with Maxi Controller
- Equipped with diagnostic LEDs indicating the operating status of the ballast
- Super-Lumen up to 15% more
- Nanotube: yes
Safety and reliability:
The diagnostic LEDs present indicate whether the ballast is switched on, in safety mode or if it is malfunctioning. In the case of a malfunction, the LEDs will also indicate the nature of the malfunction (e.g. poorly executed wiring) Thanks to its processor, the Dimlux continuously monitors the internal operating status and the quality of the connection between ballast and lamp. In the event of a loose cable or a short circuit, the ballast switches off immediately, preventing possible fire hazards.
Conventional ballasts ignite the gases inside the bulbs with electric shocks of up to 5000V, greatly increasing the risk of overloads and fires. Thanks to soft-start technology this does not happen with Dimlux.
Constant light output:
Another important thing to keep in mind is that conventional magnetic ballasts vary their efficiency and thus light output depending on the voltage of the power line to which they are connected. The same ballast can have a variation in light output of up to 10% when mounted on lines with different voltages.
The Dimlux, on the other hand, automatically stabilises the incoming current at a voltage of 230V, which guarantees a constant light output irrespective of the voltage of the power line to which it is connected.
Durability over years:
As with other electronic ballasts, a great advantage of DIMLUX is that they do not lose efficiency over the years. An analogue ballast tends to consume more and more power over time and yield less and less. It is possible that with the passage of time the increased absorption of analogue ballasts (even 4 to 5 amps for a 600W ballast) can cause an overload of the power line with possible fire hazards. Dimlux keep their consumption constant, avoiding
any risk.
Dimlux Expert Series accessories:
Additional wings long side for Alpha Optics98 reflector
Additional wings short side for Alpha Optics 98 reflector
DimluxAccessories For Reflector Cooling:
T-connectors for Dimlux reflectorfitting
Combidec duct for Dimlux reflector fitting
-
1
