Unavailable at the moment
DIMLUX - EXPERT SERIES MKII 600W EL UHF + PHILIPS GREENPOWER 600W / 400V EL BULB
Cod. 2539
Brand: DIMLUX
THE DIMLUX EXPERT MKII IS AN IMPROVED SERIES OF COMPLETE DEVICES INCLUDING AN ULTRA OPTICAL REFLECTOR.
The Dimlux Expert Series 600W EL UHF MKII is supplied with the Ultra Optics 98...
Standard price
€406,47 VAT included(22%)
THE DIMLUX EXPERT MKII IS AN IMPROVED SERIES OF COMPLETE DEVICES INCLUDING AN ULTRA OPTICAL REFLECTOR.
The Dimlux Expert Series 600W EL UHF MKII is supplied with the Ultra Optics 98 reflector and the Philips Greenpower 600W 400V EL lamp. The Ultra Optics reflector is designed according to the Single Bounce Clear Sight (SBCS) principle and is equipped with Miro Silver mirrors. This guarantees the highest possible efficiency (98%) of all available horticultural reflectors.
Equipped with adjustable side reflectors for better overlapping and to minimise wall reflection losses. Due to the open design of the reflector, the lamp is cooled passively, which is an advantage for lamp life and efficiency.There is a 50 mm socket on the reflector that can be used to significantly reduce room temperature by actively extracting air. Optional ADD-ON reflectors can also be installed to further reduce wall losses. The reflector is replaceable.
The Dimlux Expert Series 600W EL UHF MKII comes standard with a 2 metre connection cable. If a longer cable is required, it must be ordered separately.
Dimlux lighting becomes really special when it is tuned with the Dimlux Maxi Controller. You can then control up to 160 of these reflectors from a central point, adjusting the lighting output levels so that the plants always remain in the correct temperature and VPD (vapour pressure deficit) range, while at the same time adjusting CO2 distribution, heaters and humidifiers and many other features!
Key features Dimlux Expert Series 600W MKII:
- Combination lamp, ballast and reflector
- Offers 10% higher efficiency than standard HPS lights
- Ultra high frequency operation of the ballast (140Khz) increases light output from the bulb in the active photosynthetic spectrum
- Operates from a standard 230 volt domestic power supply
- Extremely high PAR levels (usable plant light)
- Very low operating temperatures
- Highly efficient with extremely low heat output
- Alpha Optics 98 reflector for wonderfully uniform light diffusion
- Supplied with Philips 600W 400V EL PPF lamp at 690W - 1341 mmol
- Suitable for illuminating an area between 0.9 and 2.3sqm depending on the power and needs of the variety being grown
Contains:
1 x 600W MKII complete luminaire (bulb / ballast / reflector),
1 x 4.0m power cable
1 x 4.0m power cable
Technical specifications Dimlux Expert Series 600W MKII:
- Dimmable to 7 different wattages:
320 Watt
390 Watt
460 Watt
530 Watt
600 W
645 Watt
720 Watt
- Power consumption at 600W is 621W, 2.7A at 230V
- Power consumption at 720W boost is 758W 3.27Amp at 230V
- System ppf at 720 W is 1408 μmol/s
- Illumination surface
at 600W is min 0.78 m2 (8.39 ft2), max 2 m2 (21.52 ft2)
at 720 W is min. 0.95 m2 (10.2 ft2), max. 2.4 m2 (25.8 ft2) - 50 mm (2″) connection for active air extraction
- Dimensions: 550mmx275mmx130mm (21.6″x10.8″x5.1″)
- Ultra High Frequency (UHF): Yes
- Dimming: Yes
- Light source: Philips lamp
- Reflector: Ultra Optics 98
- Controller: Maxi Controller
- Weight: 5.1 kg (11.24 lbs)
Safety and reliability:
The diagnostic LEDs present indicate whether the ballast is switched on, in safety mode or has any malfunction. In the case of a malfunction, the LEDs will also indicate the nature of the malfunction (e.g. poorly executed wiring) Thanks to its processor, the Dimlux continuously monitors the internal operating status and the quality of the connection between ballast and lamp. In the event of a loose cable or a short circuit, the ballast switches off immediately, preventing possible fire hazards.
Conventional ballasts ignite the gases inside the bulbs with electric shocks of up to 5000V, greatly increasing the risk of overloads and fires. Thanks to soft-start technology this does not happen with Dimlux.
Constant light output:
Another important thing to take into account is that conventional magnetic ballasts vary their efficiency and thus light output depending on the voltage of the power line to which they are connected. The same ballast can have a variation in light output of up to 10% when mounted on lines with different voltages.
The Dimlux, on the other hand, automatically stabilises the incoming current on a voltage of 230V, which guarantees a constant light output irrespective of the voltage of the power line to which it is connected.
Durability over years:
As with other electronic ballasts, a great advantage of DIMLUX is that they do not lose efficiency over the years. An analogue ballast tends to consume more and more power over time and yield less and less. It is possible that with the passage of time the increased absorption of analogue ballasts (even 4 to 5 amps for a 600W ballast) can cause an overload of the power line with possible fire hazards. Dimlux keep their consumption constant, avoiding
any risk.
Dimlux Expert Series accessories:
Additional wings long side for Alpha Optics98 reflectorAdditional wings short side for Alpha Optics 98 reflector
DimluxAccessories For Reflector Cooling:
T-connections for Dimlux reflector fittingCombidec duct for Dimlux reflector connection
Note 1: When it is time to replace the lamp, make sure it is replaced with another 400 Volt / 600 Watt Pro HPS lamp such as the Philips Greenpower 600W / 400V HPS EL. The use of a standard HPS lamp in a 400 Volt lighting system may cause damage, explosion or fire.
Warning 2: When HID lamps are switched on they are very hot. As with all high-pressure sodium and metal halide lamps, it is necessary to avoid touching the lamp with objects such as fingers or plants as this could cause serious burns or fires. In particular, avoid splashes or liquids coming into contact with the lamp as this could cause premature failure or even explosion.
-
1
€ 760,91 VAT included(22%)
€ 224,82 VAT included(22%)
