The air-cooled OptiClimate( OptiClimate Split ) works on the same principle as the water-cooled design. The only difference is that OptiClimate Split uses air as the coolant instead of water....
The air-cooled OptiClimate( OptiClimate Split ) works on the same principle as the water-cooled design. The only difference is that OptiClimate Split uses air as the coolant instead of water. OptiClimate Split has an outdoor unit (split unit) at a maximum distance of 30 metres.
The split unit comes with hoses and quick couplings. Compared to its competitors, OptiClimate has the unique property that it can dehumidify even after the desired temperature has been reached.
The air-cooled OptiClimate is available in PRO3 and PRO4 models. The specifications of both models differ, and the dehumidification function of a PRO3 and a PRO4 works slightly differently.
OptiClimate PRO3 dehumidifies by continuously finding the right balance between heating and cooling. This allows the dehumidification function to function even after the desired temperature has been reached. The dehumidification capacity of the PRO3 is more than sufficient for most applications. This is one and a half to two times more efficient than a building dryer. OptiClimate Pro = 5 systems in one machine
Cooling + Heating + Dehumidification + Circulation + Air Filtration
The OptiClimate 15000 PRO3 Split Inverter is much more electricity efficient and has a much higher dehumidification capacity than previous models.
Inverter technology ensures uniform temperature and humidity control. The Inverter enables OptiClimate to continuously adjust the temperature uniformly to the set temperature. The OptiClimate Inverter reacts directly to even the slightest difference between the set and actual temperature. Inverter technology prevents frequent switching on and off of the compressor, thus preventing power peaks. OptiClimate Inverter therefore uses less water and energy and creates more uniform temperature and humidity levels. This technology also uses 'soft start' and the compressor speed is increased gradually, avoiding a high starting current. The OptiClimate Inverter has the unique property of being multi-phase, which means that the compressor can be connected to either 230-240 V single-phase or 400 V three-phase.
It comes with an 8-metre pre-charged gas hose.
The indoor unit can be a maximum of 14 metres from the external heat sink, the 14m pipe can be ordered separately.
It is capable of dissipating the heat produced by 15 1000W lamps as well as handling the following environmental parameters:
Technical specifications:
Programmable temperature between 16° and 32° C
Relative humidity programmable between 35% and 95%
Mounts 315mm Flofilter flange
Extractor flow rate: 2500mc/h
Cooling capacity: 15 kW (increase + 8%)
Maximum energy saving compared to PRO3: 73%.
Dimensions of indoor unit: 1210 x 700 x 545 mm
Weight of indoor unit: 150 kg
Dimensions of outdoor unit: 950 x 360 x 1230 mm
Weight outdoor unit: 68.5 kg
Voltage: 230V - 400V
Power consumption: 3500W
Dehumidification capacity: 270 litres per 24 hours*.
Heating elements: 3x2700W
Phase: 1 or 3
Split unit: yes
Split unit extension: yes up to 15m
Refrigerant: R407C
* based on 80% humidity and an ambient temperature of 30 degrees Celsius
Recalculation in progress … 
